Thingiverse
Gyro
von McBeef
1
Downloads
1
Likes
0
Makes
My first model in Fusion 360 using sketch and boolean substraction. Printed on an Ender 5 with PLA at 215C
It has a 2,5mm hole in the center in which you can tap a thread to use a 3mm screw to finish the gyro.
It has a 2,5mm hole in the center in which you can tap a thread to use a 3mm screw to finish the gyro.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!