Thingiverse
Gyroid pot
by t_colon
2
Downloads
7
Likes
0
Makes
This is a pot with mesh-like walls, set using the parameters in AnkerMake Studio.
As shown in the attached image, if you set the surface thickness of the Pod to zero,
you can print a pot with Gyroid walls.
You can adjust the coarseness of the mesh by setting the infill density.
The water tray is printed as usual with a layer thickness of 0.2mm and an infill of 10%.
As shown in the attached image, if you set the surface thickness of the Pod to zero,
you can print a pot with Gyroid walls.
You can adjust the coarseness of the mesh by setting the infill density.
The water tray is printed as usual with a layer thickness of 0.2mm and an infill of 10%.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!