Slicer Discord
Gyroscopic Lamp – 3D-printbaar model van Thingiverse Thingiverse
Gyroscopic Lamp – Bild 1 Gyroscopic Lamp – Bild 2 Gyroscopic Lamp – Bild 3 Gyroscopic Lamp – Bild 4 Gyroscopic Lamp – Bild 5 Gyroscopic Lamp – Bild 6

Gyroscopic Lamp

door doby
892 Downloads
974 Likes
0 Makes
Model downloaden
Designed solely for the S.T.E.A.M technology challenge, Light It Up, this lamp was inspired by wondering if I could create something that would replicate swarming fireflies. Essentially its a lamp with gyroscopic moving parts intended for use inside and out (although its not waterproof so cannot be left outside).

The overall design of the lamp is based on a classic spherical screw cap bulb. I tried to make it look as good when operational as it does when not in use and seeing how night and day are fairly even in duration it was an important factor to consider during the design stage.
##How it works:

The lamp has 4 rings and a central orb connected with axles and bearings through which current flows. For every ring, every opposing axel is a positive and negative input, and so eventually electricity gets to the orb in the middle by linking the rings up (or so I thought, more on that later...)

Each ring has 12 yellow flicker LEDs and the orb in the center has 48 yellow flicke
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
50 mm (Klein)
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie