Thingiverse
H-Bomb Prop
door Petal3D
9
Downloads
4
Likes
0
Makes
Incorporate a falling H-Bomb in your video clip! The model has a small hole through which you may pass some fishing line. When released, the bomb follows the guide wire to its destination. For safety, you will need to add in the explosion in post-production video editing.
My motivation to create this model was to recreate the falling H-Bomb that appears in my showreel:
https://youtu.be/zapQ4spbVfk
The H-Bomb is 220mm from the tip to the fins, however may be scaled to suit your requirements. The following models are included:
v01 - Initial model without guide hole, suitable for a large format filament printer
v04 - Two-piece assembly with guide hole, suitable for a more typical filament printer.
Print using supports and about 10% infill. Join both pieces of the v04 version using epoxy. Then lightly sand the large flat and curved areas and paint the H-Bomb in your desired colour scheme.
Use coated stainless steel fishing line as your guide wire. Securely attach the line at
My motivation to create this model was to recreate the falling H-Bomb that appears in my showreel:
https://youtu.be/zapQ4spbVfk
The H-Bomb is 220mm from the tip to the fins, however may be scaled to suit your requirements. The following models are included:
v01 - Initial model without guide hole, suitable for a large format filament printer
v04 - Two-piece assembly with guide hole, suitable for a more typical filament printer.
Print using supports and about 10% infill. Join both pieces of the v04 version using epoxy. Then lightly sand the large flat and curved areas and paint the H-Bomb in your desired colour scheme.
Use coated stainless steel fishing line as your guide wire. Securely attach the line at
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
