H Configured 3D Printer

OK! .......I was so very impressed by the initial design that ckaos initiated with his http://www.thingiverse.com/thing:27202 , that I decided to take it to the next level. I utilized some of his parts except for the X-Carraige , which I increased in height to provide better support for the my Bowden Hot End.

I used Stock Drive Products (sdp-si.com) largest G2 belt which is 87.323 inches (2218 mm) long (P/N A 6R51MB09060) as well as their 10mm Self Lubricating Acetal Bearings for the 10mm Z-Axis (P/N A 7Z44MPSD10MAF), as well as a Z-axis LM10LUU version bearing holder. Use whichever you prefer.

I used http://www.thingiverse.com/thing:20850 Taylors Gregs Wades MK6 filament feed for Ultimaker, by Taylor Alexander, and designed a Bowden feed mounting bracket (short and long) to accept the filament feed system. With my Filament feeder (3mm), I was trying to utilize Wired1's http://www.thingiverse.com/thing:31322 dove tailed design in my Hot end slide.This will require addition