H2D AMS Pro2 Hinge Flipper

Inspired by AMS Flipper - better access to your P1S/X1C by Jakob_K_Design this is for the H2D. Due to the width of the H2D compared to the X1C, you can't use Jakob's design. Allows for full access to the top of the H2DTall so you're able to see through the top glass or add additional LED lighting if wanted.Tested to be strong and can hold up to 4, brand new 1KG spools.Simple design allows for a screw-less assembly of the bracket. You only need what came with your H2D AMS Combo to attached to the H2D.Does not block the TPU portDoes not block the AMS connectorAllows for easier cable management for the AMS so there aren't a lot of dangling cords. Required Hardware:2x ST3×6 bolt (existing bolts on rear panel)2x AMS transport screws or BT3x16 -AA10 minimum - 3 recommended. If you purchased the AMS with the H2D the AMS was screwed to the transport bracket. These are the same, silver screws. You keep your screws, right? Right?! Print recommendation:I printed it in Hatchbox ABS