H2D/H2S Door Post for Scraper

This is a little post designed to replace a factory installed M3 bolt in the door in both the H2D and H2S in order to hang your scraper on.BOM1x at least 20mm M3 countersunk bolt - the hole in the glass door is blind so you can go a bit longer without issue.SetupIn the top-left area of the glass door, unscrew the right M3 hex fastener. Underneath you should find a circular gasket ~1mm thick, leave this in place.Use a ~20mm M3 countersunk bolt to screw this new part into the glass door, sealing against the pre-existing gasket foam.I use this scraper, however, any scraper with a hole at least 8mm in diameter will work.