H2D PTFE Filament Guide

I keep all of my AMS2s to the right of my printer. Surprisingly, the PTFE tubing that came with my AMS2s were not long enough to reach the right side of my printer. They were slightly too short; so I had to use PTFE couplers to extend the length of the tubing. This model is a bracket that will allow you to pin 3 of these couplers to the back of your H2D. It also has the advantage of helping you keep your tubes organized and prevent hard turns, which could lead to filament loading issues. You can find other models I have released for the X1C/AMS here:https://makerworld.com/en/u/2811301167/collections/109412