H2S CAD

After finding a CAD model of the H2C that was an inaccurate representation of the physical machine and very different to my H2S, which might be a thing between the H2S, D and C? I don't know. I surveyed my H2S with a vernier caliper, micrometer and tape measure to make a 1-1 scale model. Due to whats involved in doing this, I have only done the back panel with its ancillaries and side panels with part of the glass panel; all being as measured in real life. Things to note: Add 15mm to the underside face of the side panels to get the FFL (Finish Floor Level). The poop shoot is accurate to a depth where the top drops down, meaning the true depth is incomplete, as I didn't see the point of fully modeling this because interfacing with the inside of this would be a bade idea due to machine heat. The fixings are all accurate, but I wouldn't recommend using these ever, because a lot of them are threaded screws screwed directly into plastic, which will wear out quickly - Neodymium magnets will