Thingiverse
Hack Pack Turret
von SportsPro1002
3
Downloads
4
Likes
0
Makes
This is a fully modelled recreation of Crunch Lab's Hack Pack Turret. It uses three servos and a microcontroller. I also connected it to a receiver so I could control it using an old plane RC transmitter. THE TURRET USES M4 SCREWS AND SERVO SCREWS TO BE PUT TOGETHER.
Print each of the files once except for the legs which need to be printed 4 times because there are 4 legs in the turret.
To assemble the bullets with the rubber bands, thread the rubber bands through the front hole of the bullet and screw tightly with a M4 screw.
Do not worry about the version numbers in front of some of the files. I went through a couple of iterations on some of the parts but not others. They all work with each other.
The barrel is made of an old rocket body tube that which I ended up cutting in half to give the turret more agility when moving. If you also decide to half the barrel size, you will have to double up the rubber bands for the bullets to go the same distance.
Onshape file:
h
Print each of the files once except for the legs which need to be printed 4 times because there are 4 legs in the turret.
To assemble the bullets with the rubber bands, thread the rubber bands through the front hole of the bullet and screw tightly with a M4 screw.
Do not worry about the version numbers in front of some of the files. I went through a couple of iterations on some of the parts but not others. They all work with each other.
The barrel is made of an old rocket body tube that which I ended up cutting in half to give the turret more agility when moving. If you also decide to half the barrel size, you will have to double up the rubber bands for the bullets to go the same distance.
Onshape file:
h
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
