HackerBox #0050 Enclosure

This is an enclosure for [HackerBox #0050](https://hackerboxes.com/products/hackerbox-0050)

I mounted my TFT module on pin headers connector instead of soldering it on to the board. If you soldered in your TFT, you should print `HB050_body_tft_soldered_on.stl`. I have not tested this part, but it should fit ok. The difference is only in height.

I needed to widen the mounting holes on the board with a 4mm drill bit, so I can have a little bit of wiggle room. Enclosure is fastened by four **8mm M3** screws.

Apply a tiny amount of **super glue** between the body and top (screen frame). Cut the supporting columns in the SD card reader and header pin access slots.