HackerBox Biosense Case

This is a case for the Biosense board that came in [HackerBox #0026](https://www.instructables.com/id/HackerBox-0026-BioSense/). This case does not provide a place for the 9V battery (although it does provide a hole for the battery connector wires).

To make this, you will need to print one copy of each of the board and lid cases, four copies of the buttons and two copies of the sliders.

**The lid must be printed with supports**, but the others don't need them. **Be sure that your slicer only adds supports over the build plate**. Note that the lid can be printed as it comes in the file, face down, minimizing the amount of support material, but making the supported faces look a bit ugly. You can also print the lid face up, using more support material but making the visible sides much prettier.

If you print the lid face up, be sure that you take your time and be very cautious when removing the support material. It is very easy to damage the lip on the locking tabs, particularly