Thingiverse
Hackerboxes #0087 PCB Stand
5
Downloads
4
Likes
0
Makes
This is a stand / PCB holder for Hackerboxes #0087
Press-fits onto posts with no glue required. The slightly imperfect shape produced by the printer should allow the PCB to snap right into place with a little pressure. I left room between the PCB and the stand for through-hole pins and so a battery or other circuitry could be added, running the wires through the hole in the back.
The test piece is available as well so you can make sure the posts line up correctly before printing the entire stand.
Hackerboxes are awesome, I would highly recommend them :)
Press-fits onto posts with no glue required. The slightly imperfect shape produced by the printer should allow the PCB to snap right into place with a little pressure. I left room between the PCB and the stand for through-hole pins and so a battery or other circuitry could be added, running the wires through the hole in the back.
The test piece is available as well so you can make sure the posts line up correctly before printing the entire stand.
Hackerboxes are awesome, I would highly recommend them :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
