Hagar the Horrible

Hagar, from the comic strip 'Hagar the Horrible'. Hagar is 27cm tall (including the sword) and does not require any painting when printing the pieces in the suggested colors. No supports are required. Hagar may look fierce but he is really a pussycat. Enjoy! Print instructions Print Settings Printer: FlashForge Creator X Rafts: Doesn't Matter Supports: No Resolution: .2mm Infill: 10% Notes: I also routinely print pieces that have many curves and no flat top with 5 top layers. Building the model Colors and multiple printed pieces White: horn_right horn_left face shirt boots Grey or Silver: helmet sword shield shield_handle Black: eyes (2 copies) shield_rivet (6 copies) shield_center helmet_rivet bootstrap (2 copies) Red: beard Yellow or Gold: sword_guard Brown: tunic_top tunic_bottom belt tunic_pin (2 pieces) Flesh or Peach: arm_right arm_left legs nose Assembly instructions Assembly is straight forward as per the diagram below. Of special note: The bootstrap pieces are printed flat. Simply make a loop from each bootstrap and glue the ends together. I printed them in ABS and they were highly flexible. The bootstrap then slides over the top of the shoes, so ensure you do this before gluing the shoes to the legs. I also suggest assembling the shield then gluing the shield_handle piece to the shield. Once this is all dry, the shield_handle slides into hand_left and can then be glued in.