Thingiverse
Hairspray Pump
par derailed3d
769
Téléchargements
593
Likes
4
Makes
*Please read the safety concern section below*
Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools.
I'm not a fan of removing my glass bed every time I re-apply hairspray so I usually fold a paper towel into a little square, and spray the hairspray onto there, and then wipe it on in a thin layer in the middle of the bed. This has worked great, except I need two hands to do this, and I always end up coating the other hand in hairspray.
I was modeled after a can of unscented extra super hold Aquanet, but this has fit with a wide range of compression cans.
*********NOTE*********
*********If It doesn't mist out and it ends up streaming out, (the hole may seal due to over extrusion), just take a thin needle or pin and tap it into the hole. I used a 0.5mm needle to enlarge my hole, mists perfectly now*********
1) Print this out
2) Pull off the spray nozzle on your bottle of hairspray
3) Snap this into place
4) ...
5) You're d
Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools.
I'm not a fan of removing my glass bed every time I re-apply hairspray so I usually fold a paper towel into a little square, and spray the hairspray onto there, and then wipe it on in a thin layer in the middle of the bed. This has worked great, except I need two hands to do this, and I always end up coating the other hand in hairspray.
I was modeled after a can of unscented extra super hold Aquanet, but this has fit with a wide range of compression cans.
*********NOTE*********
*********If It doesn't mist out and it ends up streaming out, (the hole may seal due to over extrusion), just take a thin needle or pin and tap it into the hole. I used a 0.5mm needle to enlarge my hole, mists perfectly now*********
1) Print this out
2) Pull off the spray nozzle on your bottle of hairspray
3) Snap this into place
4) ...
5) You're d
derailed3d publie également sur
9 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !