Hakko 888 tip clip

Clip for the Hakko 888(d) Iron holder(FH-800) to hold all your tips.

After you have ascended and bought the based chisel tip you may be looking for a place to put the conical tip, (no not the bin). This clip offers a neat solution without losing the tip cleaner.

3 and 5 tip variants in both left and right for holding up to 10 tips

Holes are designed to clamp well enough to stop the tip from coming out even if upside down but still allow 1 handed operation. After printing if the holes are too tight, you may need to deburr the inner edge of the holes, or just run the tips in and out a couple of times to get the holes worn in.

###Printing###
Print with the lip facing down on the build plate.
Support - Required underneath the inner clip.



This is a repost as the [previous post](https://www.thingiverse.com/thing:4973060) seemingly has been "lost" and doesn't show up on my profile. Pls come back thingiverse devs