Cults3D
Tool
Zum Modell
Half Set Tennis String Wrapper
0
Downloads
0
Likes
0
Makes
I've always had a bit of a problem with wrapping the left over half set of string when doing a hybrid, so I designed something that helps me out a lot hopefully it helps you too. There are 2 versions, one uses four 5x3mm magnets to help hold the 2 halves together, the other uses a small twist lock. It's very straight forward to use, put the 2 halves together, lay a small zip tie in the notches and put the end of the string through one of the small holes (located next to the notches) Wrap the string over the zip tie and continue to wrap until you can't anymore., Tighten the zip tie and separate the halves and remove the string. I would also recommend to use a second zip tie to get the other side of the string locked down and looking nice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
