Hall Effect Encoder

So I've been wanting to upgrade the pots on my DIY simulator pedals with some hall effect sensors for a while. After looking around and seeing the prices the commercial hall effect encoders go for (more than $50 each when converted from my local currency) I decided that I would go the DIY route.

Materials used:
- 3D printed parts
- 606 bearing
- Threaded guitar tuner bushing (8mm OD x 6mm ID)
- 2 x neodymium magnets (8mm x 2mm)
- 6mm x 40mm threaded rod
- 6mm nut
- Small piece of protoboard
- SS49E hall effect sensor
- 3 pin male header