Thingiverse
Halloween House 2
door MakeItWork4Me
9
Downloads
50
Likes
0
Makes
I remixed a really neat model from thiago_fmelo so that it could be printed without supports. I printed it at 210% or 6 inches high. I printed this slow since there are very delicate parts in it. I printed the outside edges at 35mm/sec and the inside at 50mm/sec. I have not tried my final draft. It is printing now. It should print well. Before, the post lights were too thin so I added vines going down them so they wouldn't break in half. Everything else was printing fine. I cleaned up some of the undersides of the roof and window sills that have also not been tested yet but those still printed. They would only be improved on this model. If you would like to see their original model, it is called Casa abobora halloween and the link is https://www.thingiverse.com/thing:7110213. I tried to keep every part of it original that I could and only changed things that allowed it to be printed with an FDM printer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!