MakerWorld
Decor
Go to Model
Halloween Pumpkin
10
Downloads
12
Likes
5
Makes
Halloween pumpkin The pumpkin is divided into two plates, one for the body and the other for the lid. The pumpkin has a slot (45mm x 20mm) for an LED tealight or small candle, although I don't recommend a candle due to the heat. Printing takes 14 hours due to the amount of supports already minimized. You can experiment and use supports only on critical areas, but it still takes 11 hours. I personally prefer to be sure everything goes smoothly, so I use the longest and safest print. Happy Halloween everyone!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
