Halloween Tap Handle

Halloween handle made for a keg tap

Print laying flat with supports, I don't know what supports work best for the skeleton.
I added more than I needed to be safe, but I couldn't get them out from inside the chest.


Threads were a little tight but if you go slow and back out a few times it should be fine.
Maybe use pliers with a cloth or tape so you don't scratch it too bad.

I also glued a pumpkin to the top.

Skeleton from:
https://www.thingiverse.com/thing:2273896

Pumpkin (not part of model, just picture):
https://www.thingiverse.com/thing:31900