Thingiverse
Electronics
Ver Modelo
HAM Logo emblem
152
Descargas
113
Likes
5
Makes
This is a HAM logo model.
Update: Made a model with coil thickness 1.2 mm instead of 0.8 mm. Both models are included.
I printed it with PLA plastic, extruder temp - 200 deg C, bed temp - 65 deg C, 0.1 mm for layer. I used several supports, but coil loops without support also printed well. Raft is on your decision, maybe it is not needed due to big surface.
Update: Made a model with coil thickness 1.2 mm instead of 0.8 mm. Both models are included.
I printed it with PLA plastic, extruder temp - 200 deg C, bed temp - 65 deg C, 0.1 mm for layer. I used several supports, but coil loops without support also printed well. Raft is on your decision, maybe it is not needed due to big surface.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
