Hammer Rack - Skadis

I have a few hammers that I sue regularly when working in the garage, and after setting up the Ikea Skadis pegboard system the next stage was to store them on the Skadis Board. I started out with simple hooks, but they were taking up too much space so I came up with this simple rack that can hold 4 hammers. It is secured to the board using T-clips.The design is not the most elegant, but it is fully functional and strong. It's really only 4 tubes joined and then added to a backing with the T-clip system. Because it is holding hammers, there is a bit of weight involved when fully loaded, and I may have made it too strong. However, I prefer to only print something once rather than twice because it wasn't strong enough.It's been in use for a few months now and is working very well. So I though someone else might find this useful.