Thingiverse
Hammershot front
door LordTucTuc
3
Downloads
2
Likes
0
Makes
I couldn't find the right front for my Hammershot so I designed this one. It might require some post-processing. I also blended the edges with expoxy.
The centerpiece is based on the following design by deusnefum:
https://www.thingiverse.com/thing:3263973
The centerpiece clamps right into the shell. The part for the right was then glued to the shell and the centerpiece. The other part was glued to the left half of the shell. The connector may just used with friction fit, but I glued it into the centerpiece-right_part. That way there is good connection but it is still possible to open the shell as intended.
The centerpiece is based on the following design by deusnefum:
https://www.thingiverse.com/thing:3263973
The centerpiece clamps right into the shell. The part for the right was then glued to the shell and the centerpiece. The other part was glued to the left half of the shell. The connector may just used with friction fit, but I glued it into the centerpiece-right_part. That way there is good connection but it is still possible to open the shell as intended.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!