Slicer Discord
Hand/Ball Pump Mount for Multiboard – Modelo 3D imprimible de MakerWorld MakerWorld
Organizers

Hand/Ball Pump Mount for Multiboard

5 Descargas
0 Likes
2 Makes
Ver Modelo
I picked up a new Ball Pump kit from amazon and it came with a little cheap and worthless bag that will get lost in no time. So i figured i would make a way to neatly organize and hang up my manual hand/ball pump where it can easily be seen on my multiboard. Not much to it, just the octagonal push mount so you can use a normal snap fitting, big screw or mounting feet and it will push in. I made the octagonal diameter of the push part at 6.71r (13.42 diameter). So it should fit nice and snug and no worrying about it falling out. Figured this wouldn't be super popular but wanted to share it none the less. Has a spot for everything in this kit. The Pump itself, the extension cable, the tire pressure meter and holes for up to 6 of the needle attachments (the kit i bought came with 3, but there was room on the model to make additional)
Categoría
Organizers
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección