hand shower support

Hello to all of you out there,

Here is my proposal for a hand-shower support (as the orignal one broke)
the thing is composed of 4 parts . The knob should be printed twice.

The orientation of the hand-shower is possible in most all direction, hight, tilt, rotation.
The look and feel is "industrial" (you'll like it or not !!)
The support is designed to clamp a 19mm diameter tube.
No need to disassemble the water tube to clamp the support arround.

All the parts print well without support , just find the right base plate.
A few hints :
- The two piece that clamp the tube are printed verticaly
- The knob is printed on the largest flat face
- The hand-shower support is printed on its base. (on the flat part of the joint)

To assemble all these you will need :
2xM4x25 and nuts for the clamp
2xM5x35 and nuts for what is tightened by the knob.

Have fun, and stay safe.

If you like this thing: thumb up , post a make or even better tip the designer.