Handgun Stand

A 3d printed handgun stand that slots into the accessory rail. Print with the base flat on the build plate; no supports are necessary as the largest overhang is 45 degrees. A variant with a taller slot is provided for bulkier accessory rails, I found that this size was appropriate for a PSA Rock while the smaller variant is a tight fit on both a Springfield XDM and Glock 45.

The assumed width at the widest point on the accessory rail is 0.83" while the true spec for a picatinny rail is 0.835", so scale by 1-2% if you prefer a looser fit or more if you expect a significant amount of shrinkage. Example print is shown using Extra Draft preset on a BambuLab A1 with Inland White PLA+.