Handing Magic L Handle Extender

The Handing Magic L rod is a nice rod but the handle was just too short for my liking. I designed this and now i can cast two handed.

The fit will be tight by design. You will need to work the cork handle to get it to slide on and then start spinning the extender while moving up the handle (the inside of the handle has a threading for better grip). If you think its too tight then increase dimensions in your slicer of choice by 1%. The tighter the fit the better for obvious reasons.

i bet a thin layer of epoxy or wood glue would work great before "threading" on the extender but so far has not been needed for me.

This will also work on any handle (cork, foam, ECT) with a 23.5 to 25ish MM OD handle.

Tight Lines!