Thingiverse
Handle for Kaffelogic Roaster
door nicolaiS
73
Downloads
69
Likes
1
Makes
I was made aware that there is a slight change to the Kaffelogic Chassis.
Early editions like the one I had the distance between the mounting holes were 111mm, where the later releases (Including the US version) is 114mm.
Therefore I adjusted dimensions of the original design.
It is easy to measure the distance between the middle of the two mounting screws with a caliper.
You will need to replace the original screws with M4 10mm
Print on the side and avoid supports
Early editions like the one I had the distance between the mounting holes were 111mm, where the later releases (Including the US version) is 114mm.
Therefore I adjusted dimensions of the original design.
It is easy to measure the distance between the middle of the two mounting screws with a caliper.
You will need to replace the original screws with M4 10mm
Print on the side and avoid supports
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!