Thingiverse
Handlebar Inner Bar ends
por gabaza
0
Descargas
4
Likes
0
Makes
**DIY inner bar ends for flat handlebars.**
Clamp diameter: 22.2mm
Extra hardware needed:
- 1x M4 screw (7mm ∅ head, ~15mm long)
- 1x M4 nut
This is an *asymmetrical* design so make sure to print a mirrored version too in order to have one on each side of your handlebar!
Still an early version! I'm open to critics and feedback : )
Clamp diameter: 22.2mm
Extra hardware needed:
- 1x M4 screw (7mm ∅ head, ~15mm long)
- 1x M4 nut
This is an *asymmetrical* design so make sure to print a mirrored version too in order to have one on each side of your handlebar!
Still an early version! I'm open to critics and feedback : )
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
