Thingiverse

Handy Scraper

par FishNinJay

2 Téléchargements

0 Likes

0 Makes

This is a pusher or scraper to add onto the front of the Mega X print hotend assembly. There are 2 front bolts on top, which can be removed. No need to replace with longer bolts. These will work fine. Should fit nicely on the front of the Mega X print unit, but not sure about the other Mega 3D Printer, but I suspect they use the same, so should work. This scraper bottom edge is just a millimeter or two above the nozzel tip, so it should work for even fairly low-profile items.. which is the main reason for this scraper. Otherwise, you could use the same code, and just use the print head to sweep taller prints off the bed. I haven't quite figured out how to minimize adhesion enough to allow this scraper to successfully sweep off my prints. There's a video of my unsuccessful attempt under Post Printing here, so appreciate any help in Comments below. Thanks.

3d printer 3D tool Anycubic Anycubic I3 Mega Anycubic Mega X Arduino Mega Mega X Print Pusher pusher scraper tool 3d printer 3D tool Anycubic Anycubic I3 Mega Anycubic Mega X Arduino Mega Mega X Print Pusher pusher scraper tool

Source

Thingiverse

Ce qu'il faut pour imprimer: Intermédiaire Confiance faible

Monobloc Visserie requise

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 1/3

Imprimante

FDM / FFF

Format de fichier