Hang Board Grip Trainer

Finger board grip trainer, I've printed one so far and works really well so I'll print a second.

Feel free to take the CAD and adjust it to your hand size/ability. Obviously be careful when hanging on anything 3D Printed, by using this you are excepting responsibility if it breaks/fails in anyway.

One bigger and one smaller crimp hold and one single finger hold. (Only for experienced climbers)

Can be hung up with strong rope or screwed into a board.

Rope - If you tie it like I did in the photo you can then adjust the angle of the grip by sliding the knot, on both sides, back and forth.

Screws - 5 screws, use whatever is suitable for your wall/board you're attaching it to. If attaching it to a board, it is designed so that the bottom screws are above the single finger hole so that the hole can stick out below the board.