Thingiverse
Hangable Phone Mounting Dock
door brendonv101
4
Downloads
1
Likes
0
Makes
Here is a hanging phone mount which is designed to mount on a 5mm wide rail. In my case it's the girts or top hat channel in my shed/garage but you can hang it off any lipped edge.
Hanging edge goes down 20mm and is 5mm deep.
Phone Cradle size is 70mm wide.
V2 is 76mm wide and has a larger overall mount. Better for phones with large cases.
Printing on its side will be stronger but up and down is fine (Quicker).
0.2mm
3 layers
30% Gyroid Infill
Tree Supports
PETG used due to being near heat.
Hanging edge goes down 20mm and is 5mm deep.
Phone Cradle size is 70mm wide.
V2 is 76mm wide and has a larger overall mount. Better for phones with large cases.
Printing on its side will be stronger but up and down is fine (Quicker).
0.2mm
3 layers
30% Gyroid Infill
Tree Supports
PETG used due to being near heat.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
