hanged containers

Durable hanged container can be used in bathroom for mounting some bottles or in bedroom for kid water bottle. Mounting should adapt to thickness range about 18–22 mmOptimized to improve printability. I recommend using PETG as PET might be to stiff and break (untested, but if you succeed let me know) In case you want to create your own print profile:I do not recommend using smaller layer height than 0.16mm when printing with PETG, I had few print failures with smaller height (small blob created on edge of infill and outer wall and growing with each layer slowly ruining whole print)brim is a little bit annoying to remove, but it's highly recommended as holding arm might detach from bed during printing without it.