Thingiverse
Hanging Bird Feeder
von sat481
5
Downloads
9
Likes
0
Makes
My wife wanted a new bird feeder to leave some old bread on for the little birds. She was so keen she got on my laptop and with a few tips from me, created this bird feeder in Fusion 360. Not bad for her 1st attempt of CAD. Very proud of her.
The feeder printed well in PETG since it is going outside. Just use a few pieces of string to hang it from somewhere and wait for the birds to flock to it :)
It does need supports on, but they are very small at the corners.
The feeder printed well in PETG since it is going outside. Just use a few pieces of string to hang it from somewhere and wait for the birds to flock to it :)
It does need supports on, but they are very small at the corners.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
