Hanging Pot

This is my take on a basic hanging plater. I was going for a clean and modern aesthetic, but also wanted to incorporate both wood and marble PLA's into it. The Different sizes are just straight rescales of the original. I am including a Non-AMS version, though admittedly I have not tested that specific profile. There is a minor issue with the bottom of the exterior pot, on the inside I just couldn't bridge it well and the layers just weren't clean. Ultimately it doesn't effect the pot or its outward appearance, so rather than wasting material on supports I have opted to leave it as is. Feel free to add supports if it is a problem for you. The Insert is optional. It has some holes in the top to help get a hold of it once in place. It has a flat base to allow it to sit upright in tube or sink for watering. The drain holes are a little large, this is a personal preference for me as I like to add paper towels or coffee filters before my dirt to help retain soil. The holes are large to allo