Thingiverse
Hanging Spool Holder
por Chirpy8
7
Descargas
4
Likes
0
Makes
Yet Another Spool Holder. Just my take on a spool holder with bearings for a smooth ride. I didn't like any of the other hanging spool holders that I could find. I wanted to suspend the spool from a cabinet above my printers.
This one incorporates 3 x 608 bearings to allow the spool to turn freely. They are spaced to cater for the common spool widths, so there should be at least two bearings in use at a time.
It's been designed to limit bounce when filament is undergoing feed and extraction, which J shaped spool holders can suffer from.
Printed with tree supports (at 5%) for the bearing holes. 15% infill at most, and a layer height of 0.25.
Printed flat on a CR-6 SE.
This one incorporates 3 x 608 bearings to allow the spool to turn freely. They are spaced to cater for the common spool widths, so there should be at least two bearings in use at a time.
It's been designed to limit bounce when filament is undergoing feed and extraction, which J shaped spool holders can suffer from.
Printed with tree supports (at 5%) for the bearing holes. 15% infill at most, and a layer height of 0.25.
Printed flat on a CR-6 SE.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
