Hanging wall vase

A little while ago, I was asked by my sister to see if I could design and print some replacement wall pots. The ones she had were beginning to break. So I set to work and came up with these. There didn’t seem to be very many versions for wall hugging pots, and those I did find rather flimsy, which would’ve made them prone to breaking over time. Perhaps I might have over engineered these, and they are certainly thicker and far more sturdy than the pots they replace. I would much prefer to just print once and use a little bit more filament, than having to reprint in a couple of years time. So I thought I’d put these up here in case anybody might find them useful. They certainly look good on my sister‘s wall with her plants. There are two sizes, neither of which very large, but I’m sure they could be upsized if you wished to do so. I’ve also included a keyhole hanging point on the back of each pot. The sizes are detailed below as depth, width and height.Small: 85x100x90mmLarger: 92x110x11