Thingiverse
Hango Drone Tether Combo
von wispdrone
0
Downloads
1
Likes
0
Makes
Drone Tether (drone end) 3D Printable Parts ( requires glue)
These are solid pieces of a drone tethering system.
H
l l
0
Print the H first ,
then each stem (long or short) measure
then the ring part
First, always re-adjust the size to meet your drone chassis size.
Print 100 % solid pieces for best results.
Use Glue and Spray for best results on each piece, holding part in place while spaying quick set glue spray.
Enjoy,
WISPdrone.co
These are solid pieces of a drone tethering system.
H
l l
0
Print the H first ,
then each stem (long or short) measure
then the ring part
First, always re-adjust the size to meet your drone chassis size.
Print 100 % solid pieces for best results.
Use Glue and Spray for best results on each piece, holding part in place while spaying quick set glue spray.
Enjoy,
WISPdrone.co
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
