Thingiverse
Hantek dso LCD Adapter
von jasonmrc
1
Downloads
0
Likes
0
Makes
Designed this LCD adapter to hold the pcb that sits behind the LCD.
The factory uses double sided foam tape and silicone on the corners to secure the board.
My design allows the board to slide easily in the 3d printed part and can be installed with double sided tape.
Make sure to clean the pcb before installing into the 3d printed part .
The factory uses double sided foam tape and silicone on the corners to secure the board.
My design allows the board to slide easily in the 3d printed part and can be installed with double sided tape.
Make sure to clean the pcb before installing into the 3d printed part .
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!