Harbor Freight 40pc Socket Set Insert 62843

My Patreon if you wanna throw me a dollar! https://www.patreon.com/pacodeth

This is a insert for the good ol Harbor Freight 40 PC Socket Set that normally comes with a razor thin clear plastic insert that tends to bend, malform, and just not hold the sockets in place well. Also included is a piece you can print to wrap around the case, as the snap close on the Harbor Freight case tends to break.

Harbor Freight SKU's: 62843, 47902, 61328, 63015, 975

Created in Sketchup, and I included the Sketchup files if you wish to make any changes. I measured every single socket in the set with a digital caliper, and multiplied that measurement by 1.053 which seemed to give the best fit for the PLA shrinkage and the like. Most sockets just sit in place with little wiggle room, a few might go in a bit tight, but the heights have been set to prevent them from falling out when flipping the case upside down.