Thingiverse
Harbor Freight Clamp Holder
door sjstrutt
87
Downloads
44
Likes
0
Makes
Based on Harbor Freight Clamp Holder by Fillitup309 but modified to print as a single piece with no supports. I barely made any changes at all.
----
Organize your Harbor Freight clamps.
4, 6, or 8 clamp holder (6 should be short enough to print on most printer beds).
Use multiple clamp holders 12" apart (one above the next) to have a clamp wall/area where you can stack a grid of clamps. Will post photos when mine is setup.
----
Organize your Harbor Freight clamps.
4, 6, or 8 clamp holder (6 should be short enough to print on most printer beds).
Use multiple clamp holders 12" apart (one above the next) to have a clamp wall/area where you can stack a grid of clamps. Will post photos when mine is setup.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!