Thingiverse
Harbor Freight File Stand
von ndyrland
306
Downloads
170
Likes
2
Makes
This is a stand I designed for holding the cheap-o but handy diamond grit file set I bought from harbor freight. I would recommend printing with the "x" side on the build plate, supports are optional but helpful.
To avoid any tippy-ness, I added some small clamps that fit around the base, allowing you to screw them into your worktable. I would recommend printing these with a very high infill percentage. especially if you plan on using a screw bigger than M5.
To avoid any tippy-ness, I added some small clamps that fit around the base, allowing you to screw them into your worktable. I would recommend printing these with a very high infill percentage. especially if you plan on using a screw bigger than M5.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
