MakerWorld
Organizers
Zum Modell
Harbor Freight Mini Toolbox Gridfinity Baseplates
482
Downloads
231
Likes
267
Makes
IMPORTANT: The drawer design was slightly tweaked at some point, and the drawer inserts in this model will not work with the newer toolbox. This is designed for the original V1 version of the toolbox. Please do not give me a bad review due to attempting to put these in an incompatible toolbox.The Harbor Freight (U.S. General) mini toolbox is all the rage right now. I picked up a couple for myself and could not find any existing grids, so I took it upon myself to create them. The top grid has a half option as it does not fit on a 256x256mm printed. Just print two and butt them up together, I use a 2 by x bin (1 square on each half) to keep them aligned and together. The drawer ones fit, but you have to flex them a bit to get them around the brackets and screws in the drawers. Removing the nonslip liner makes it a little easier, but it is possible to leave those in. Make sure to cut off any elephant's foot that may occur, as it would make the base too wide. I used a deburring tool fo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!