Thingiverse
Harddisk Board Mounting Bracket
door Workshopshed
12
Downloads
4
Likes
1
Makes
I needed to mount a 3.5inch hard disk on a board for a clustering project I was working on so I made a couple of little brackets to screw it down.
I printed it in ABS and on its side for strength. If you were using a softer material such as PLA you might want to make the brackets a bit bigger.
I printed it in ABS and on its side for strength. If you were using a softer material such as PLA you might want to make the brackets a bit bigger.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
