Thingiverse
Harmony's Dish
von Rajaa
139
Downloads
126
Likes
2
Makes
https://www.youtube.com/watch?v=EunCh0tHWT8
6x M3 8mm, or 5mm Countersunk (flat).
Don't tighten the screws too much! The parts should move freely.
Use support.
The orientation is up to you, depends on what surface you want it to look nicer :)
6x M3 8mm, or 5mm Countersunk (flat).
Don't tighten the screws too much! The parts should move freely.
Use support.
The orientation is up to you, depends on what surface you want it to look nicer :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!