Thingiverse
Harmony Xbox 360 Remote Holder
von lazychris2000
1
Downloads
1
Likes
0
Makes
Original holder (https://www.thingiverse.com/thing:1373661) wasn't quite deep enough for my 360 remote, so I remixed it to be a few mm deeper and added screw holes.
I had to lightly hit it with my countersink bit to the holes after printing because the holes came out slightly oblong and caused the screw head to stick out unacceptably far....probably should have used supports. Holes are supposed to fit standard drywall screws.
For the record, my room is not Big Bird yellow like the one picture makes it look, but for some reason my phone swears it is with the blue filament.
I had to lightly hit it with my countersink bit to the holes after printing because the holes came out slightly oblong and caused the screw head to stick out unacceptably far....probably should have used supports. Holes are supposed to fit standard drywall screws.
For the record, my room is not Big Bird yellow like the one picture makes it look, but for some reason my phone swears it is with the blue filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
