Harry Potter Hueforge

Only filament swaps are needed, no MMU or AMS is required, but AMS makes it a bit easier. To get the intended look use the filament swaps as described. You can change the colors to get the desired look, but I do not recommend adjusting the other settings. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: SILK PLA mika3d silk black Transmission Distance: 5 SILK PLA mika3d silk sapphire blue Transmission Distance: 5 SILK PLA mika3d silk red Transmission Distance: 5 SILK PLA mika3d silk salmon orange Transmission Distance: 5 Swap Instructions: Start with silk black At layer #9 (0.8mm) swap to silk sapphire blue At layer #10 (0.88mm) swap to silk red At layer #17 (1.44mm) swap to silk salmon orange for the rest. If you do not have this filament you can use any red, blue, black , and a peach or skin color filament. to get a similar look. The layers are thin, so the color below shows through to give it the desired look. I'm sure you can achieve th