Thingiverse
HASSBOX
door infernocs
65
Downloads
47
Likes
0
Makes
So anyone who has a Home assistant setup running on a rpi3 this is for you :)
Print at 0,2mm layers with 0,4mm nozzle (0,2 or 0,1 is also fine) There is a lot of bridges inside the logo so please take care to check your bridging settings, I did 100% parts fan and it turned out nice, like a mesh or net.
Print the halves with the logo part facing down.
!! USB Cables need to be 90 degree angle versions or really small to fit !!
Print at 0,2mm layers with 0,4mm nozzle (0,2 or 0,1 is also fine) There is a lot of bridges inside the logo so please take care to check your bridging settings, I did 100% parts fan and it turned out nice, like a mesh or net.
Print the halves with the logo part facing down.
!! USB Cables need to be 90 degree angle versions or really small to fit !!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!