Slicer Discord
Hate Ticks? – 3D-printbaar model van Thingiverse Thingiverse

Hate Ticks?

door jpearce
60 Downloads
73 Likes
1 Makes
Model downloaden
This is an experimental device to remove ticks. Put tick through the big hole - flat side against your skin. Pull along skin while pressing down to force the tick down the channel. Make sure you get the 'blades' under the head. Fortunately, we are at the end of tick season here...

I make no warranties that this will actually do anything useful or keep ticks from vomiting disease into your bloodstream. If you do happen to get a tick, print it out, give it a try before you reach for the tweezers and let me know how it went. Thanks!

This component is part of an open source lab library, by the [Michigan Tech's Open Sustainability Technology Research Group](http://www.appropedia.org/Category:MOST).

For similar see the [Open-Source Lab How to Build Your Own Hardware and Reduce Research Costs](http://www.appropedia.org/Open-source_Lab)
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie